Phoenix os no sound over hdmi11/9/2023 If you have an update to install then then first boot usually take about 10 minutes. How long does the process take to complete HDANYWHERE(HDA) recommends that every MHUB install goes through its first boot process to ensure that the MHUB is setup correctly. Take a look at a full list of commands that you can say to your Echo. Here’s a table of all the commands you can tell your MHUB to do… Ensure there are no other devices linked to the Alexa that have the same name as the zone.When you try to control a zone Alexa says the command isnt supported. Ensure you have backed up the system to cloud after configuring the Alexa Skill on MHUB-OS.Ensure only 1 system is linked with the cloud account being used.Check you cloud account details were entered correctly.When searching for devices, nothing is found.Read more about Sequences and Scheduling. You can instruct MHUB to change the channel on that source device.You can tell MHUB to switch to the source device with has the football on it.You can select if you want MHUB to turn your TV on and adjust the volume.Inside MHUB-OS we can configure exactly what “football” does. Turn on… (this invokes the smarthome skill)įootball (this is your custom name for the Sequence, it can be anything you want) You can configure all those actions in what we call a “Sequence”.Īlexa (this wakes up your Amazon Dot/Echo/Show) The correct source input might need to be selected on MHUB and finally that source will need to navigate to the channel hosting the football. It might appear like a very simple command but there are a number of things that need to happen in order to watch football! First the TV might need to turn on, but in which room? The volume might need to be set to a desired limit. Let’s take the command “Alexa, Turn on football” as an example. You have an Amazon Alexa enabled device, such as Amazon Dot/Echo/ShowĬonfigure voice commands to do exactly what you want.You have completed input mapping in MHUB-OS.You have downloaded uControl packs for all displays and source devices you want to control.You have MHUB-OS version 8.10 or higher installed on your MHUB.You have completed the first-boot procedure within MHUB-OS.Check here: What you need to get your MHUB to respond to voice commands: We cannot guarantee voice services or offer support to those territories not officially supported by Amazon. *Before you activate the Alexa Voice Service with your MHUB, make sure Amazon support your territory and version.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |